The Ace Link Armor SKELETAC Back MOLLE Panel is a rear-mount attachment accessory built exclusively for the Skeletac Plate Carrier. It straps securely onto the back of the carrier and converts unused rear real estate into a fully modular equipment platform. Laser-cut MOLLE attach points accept utility pouches, gas mask pouches, and breacher pouches. Slide-fastener channels along both edges accept the Ace Link MAP Pack for extended load-out capacity, and an integrated Velcro field supports ID placards.

Who this is for

• Skeletac Plate Carrier users who need rear-panel pouch capacity without swapping to a heavier or bulkier carrier system
• Field and patrol operators running utility, gas mask, or breacher pouches that require a dedicated, stable attachment surface behind the primary carrier
• Skeletac MAP Pack users who want a dedicated mounting interface for the pack rather than improvising attachment across the carrier's existing hardware

Compatibility with parent armor

The Back MOLLE Panel attaches directly to the rear of the Ace Link Skeletac Plate Carrier. The slide-fastener areas on both left and right edges of the panel provide a dedicated interface for the Ace Link MAP Pack, enabling extended carry for additional equipment during prolonged operations. The integrated Velcro surface accommodates standard-sized ID placards.

Function

Laser-cut MOLLE attach points run across the panel face, providing organized, low-snag attachment for utility pouches, gas mask pouches, and breacher pouches. The panel expands the modular capacity of the Skeletac system without adding a full pack frame, keeping the carrier's profile and weight distribution manageable. The Velcro field on the panel face handles ID placard attachment, a common mission requirement that the carrier's main body does not address alone.

Specifications

Frequently asked questions

What does this panel work with?

The Back MOLLE Panel is designed for the Ace Link Armor Skeletac Plate Carrier. It also interfaces directly with the Skeletac MAP Pack via the slide-fastener channels on both panel edges. If you are running a different carrier and want to confirm fit before ordering, contact us.

Does this fit other plate carriers besides the Skeletac?

It depends. The panel is designed and marketed for the Skeletac Plate Carrier specifically. Compatibility with third-party carriers is not specified. Contact us before ordering if you intend to use this panel on a non-Skeletac system.

Is this panel NIJ-rated on its own?

No. The SKELETAC Back MOLLE Panel provides no ballistic protection. It is a modular organizational accessory that adds pouch and pack attachment capacity to the rear of the Skeletac Plate Carrier.

Does this add weight or just coverage?

The panel adds organizational capacity and a mounting interface — not ballistic coverage. It increases the usable surface area for pouches, a gas mask, breacher gear, or the MAP Pack on the back of your carrier.

How does this install?

The Back MOLLE Panel straps onto the rear of the Skeletac Plate Carrier. The MAP Pack connects through slide-fastener areas running along both side edges. ID placards attach to the integrated Velcro field on the panel face.

Can I use this without the Skeletac Plate Carrier?

It depends. The panel is designed to strap onto the Skeletac Plate Carrier. Using it as a standalone item or mounting it on an unrelated system is outside its intended application. Contact us if you have a specific configuration in mind.