Yes, absolutely. The GT13 comes fitted with a Type G British 3-Pin plug and is rated at 240V, which is the standard voltage used across the UAE, Saudi Arabia, and the wider GCC region. You can plug it directly into any standard wall socket without needing a converter or adapter.

A tacker drives U-shaped staples, which are ideal for gripping fabric, mesh, or sheet materials across a wider surface area. A nailer drives straight brad nails, which penetrate deeper and leave a smaller, cleaner hole — preferred for trim, molding, and fine woodwork. The ID GT13 is a 2-in-1 machine that handles both, accepting Type 53 staples (8–16mm) and Type F/L brad nails (15–16mm), making it one of the most versatile fastening tools in its class.

The GT13 is built for both. Its 5A corded electric motor provides consistent, fade-free power that professionals rely on for high-volume tasks like upholstery production, carpentry, and insulation installation. At the same time, its straightforward operation and included guide book make it equally accessible for home DIY users tackling projects like picture framing, furniture repair, or wall paneling.

The GT13 is compatible with Type 53 staples ranging from 8mm to 16mm in length, which are the most widely available staple type on the market. It also accepts Type F and Type L brad nails at 15–16mm. Always ensure you are using the correct fastener type and size to avoid jams and ensure a clean, secure drive. Using non-compatible staples or nails may damage the tool or result in misfires.

The GT13 features a high-capacity magazine that holds up to 100 staples at a time, significantly reducing the frequency of reloads during extended work sessions. To reload, simply release the magazine latch, slide out the empty channel, insert a fresh strip of compatible Type 53 staples, and close the magazine until it clicks securely into place. Refer to the included guide book for illustrated step-by-step reloading instructions.

Yes. The GT13 is designed to fasten a wide range of lightweight materials including wood, plastic, drywall, and fabric. For thinner or more delicate materials like plastic sheeting or thin fabric, use the shorter 8mm staples to avoid over-penetration. For denser materials like MDF, plywood, or hardwood trim, the longer 16mm staples or brad nails will provide a stronger, more secure hold.

Jamming is most commonly caused by using incorrect staple sizes or non-compatible fastener types. First, disconnect the tool from the power outlet. Then open the magazine, remove any jammed staples carefully using a flat tool, and inspect the driver channel for debris. Reload with the correct Type 53 staples (8–16mm) or Type F/L brad nails (15–16mm) and ensure the magazine is fully closed before reconnecting power. Refer to the guide book for a detailed jam-clearing procedure.

Insufficient penetration depth is usually caused by one of two things: using a staple length that is too short for the material thickness, or pressing the tool against the surface at an angle rather than flush and perpendicular. Try switching to a longer staple within the 8–16mm range for thicker materials, and ensure the nose of the tool is pressed firmly and squarely against the work surface before pulling the trigger. If the issue persists, check that the power supply is delivering a stable 240V connection.

The GT13's 5A corded electric motor is designed for sustained use, making it suitable for professional and semi-professional applications. However, as with all power tools, it is good practice to allow the tool to rest briefly during very extended sessions to maintain optimal performance and longevity. Avoid blocking the ventilation areas on the tool body, and always operate in a well-ventilated workspace. If the tool feels unusually hot to the touch, disconnect it from power and allow it to cool before resuming work.