Yes. The ID MIX164H is rated for 220–240V at 50/60Hz, which is fully compatible with the UAE's standard power supply (220–240V, 50Hz). It also comes fitted with a Type G (British 3-Pin) plug, which is the standard plug type used throughout the UAE, so no adapter is required.

A standard drill is designed for rotational cutting and driving, not sustained mixing. The ID MIX164H is purpose-built for mixing, with a 900W motor optimised for the continuous torque loads that thick materials create. Its 500 RPM controlled speed also prevents the air entrainment and splashing that high-speed drills cause. For occasional, light mixing a drill attachment may suffice, but for professional or regular use, a dedicated mixer like the MIX164H is significantly more efficient and safer.

The MIX164H ships as a complete, ready-to-use kit. Inside the box you will find the mixer machine itself, a 160mm stirring paddle pre-threaded to M14, a side handle for two-handed stability, a replacement auto-stop carbon brush set so you have a spare on hand, and a guide book covering safe operation and maintenance procedures.

The MIX164H is well-suited for a broad range of paints, primers, emulsions, and wall coatings, as well as heavier materials such as tile adhesives, grouts, plaster, and cement-based compounds. It can also handle epoxy resins and industrial coatings. The 900W motor provides sufficient torque for medium-to-high viscosity materials, while the 500 RPM speed keeps the process controlled and splash-free.

Yes. The MIX164H uses an industry-standard M14 thread on its spindle, which is compatible with a wide range of aftermarket mixing paddles available in the market. You can use paddles up to 160mm in diameter. Different paddle styles — such as spiral, whisk, or ribbon paddles — can be used depending on the material viscosity and the mixing result you need.

The MIX164H has a net weight of 2.3 kg, making it relatively lightweight for a 900W professional mixer. It is also supplied with a side handle, allowing for a secure two-handed grip that gives you better control over direction and pressure, especially when working with thicker, more resistant materials.

The most likely cause is the auto-stop carbon brush system activating. This is a built-in safety feature: when the carbon brushes wear down to their minimum safe length, the machine automatically cuts power to protect the motor from damage. The solution is straightforward — replace the carbon brushes using the spare auto-stop carbon brush set included in the box. Refer to the guide book for step-by-step replacement instructions.

Air bubbles are typically caused by mixing too fast or lifting the paddle out of the material while the machine is running. The MIX164H's 500 RPM controlled speed is specifically designed to minimise air entrainment. To further reduce bubbles: keep the paddle fully submerged at all times during mixing, move the paddle slowly in a figure-eight pattern, and avoid lifting it above the surface of the material until the machine has come to a complete stop.

The MIX164H is built with a double insulation system, which means the internal electrical components are fully isolated from the outer casing, significantly reducing the risk of electric shock in the event of internal insulation failure. While this provides an important layer of protection, it is still best practice to avoid direct exposure to rain or standing water, keep the power cable away from wet surfaces, and always use a residual current device (RCD) when operating power tools in damp environments.