The IDEAL TCT Blade [Wood] is designed for mitre saws that accept a 250mm (10") blade with a 30mm bore. This is one of the most common arbor sizes across major power tool brands. Always verify your saw's blade diameter and bore specification in the user manual before purchasing. If your saw uses a different bore size, reduction rings may be available separately.

Tooth count directly affects cut quality and speed. A 24-tooth blade removes material quickly but leaves a rougher finish — ideal for framing and rough cuts. A 40-tooth blade offers a balance of speed and finish. This 60-tooth TCT blade is optimised for fine, smooth cuts with minimal tear-out, making it the preferred choice for finish carpentry, cabinetry, and any application where surface quality matters. The trade-off is a slightly slower feed rate, which is standard for high-finish blades.

Tungsten Carbide Tipped (TCT) blades outlast standard high-speed steel (HSS) blades significantly. Carbide is far harder and more heat-resistant, meaning the cutting edge stays sharp through thousands of cuts. For professional use, TCT blades offer a lower cost-per-cut over time, reduced downtime from blade changes, and consistently cleaner results — particularly important when cutting hardwoods or abrasive engineered materials like MDF and laminate.

This blade is suitable for cutting a wide range of wood-based materials, including solid hardwoods (oak, walnut, teak), softwoods (pine, cedar), MDF, plywood, chipboard, and laminated boards. The 60-tooth configuration is particularly effective where a clean, splinter-free edge is required. It is not designed for cutting metal, masonry, or plastics — always use the correct blade type for non-wood materials.

The IDEAL TCT Blade [Wood] is rated to a maximum of 5,500 RPM, which corresponds to a peripheral tip speed of 80 m/s. Never operate this blade above its rated speed. Always confirm your saw's no-load RPM is at or below this limit before use. Operating above the rated speed is a serious safety hazard and will void any applicable warranty.

Installation is straightforward for any standard 250mm mitre saw with a 30mm arbor. The blade ships with a washer set to ensure correct seating and clamping. Always ensure the saw is fully powered off and unplugged before changing blades. Mount the blade with the tooth rotation direction matching the arrow marked on the blade body, tighten the arbor nut to the manufacturer's specified torque, and replace the blade guard before operating.

Splintering is most commonly caused by a low tooth count, a dull blade, or incorrect feed rate. The 60-tooth TCT configuration of this blade is specifically designed to minimise tear-out and produce clean, chip-free edges on wood. If you are currently using a 24 or 40-tooth blade, upgrading to this 60-tooth blade will produce a noticeably cleaner finish. Also ensure you are feeding the material at a steady, controlled pace — forcing the cut increases the risk of splintering regardless of blade quality.

Slow cutting with a 60-tooth blade is normal compared to coarser blades — the higher tooth count means each tooth takes a smaller bite, which is the trade-off for a finer finish. However, if performance has degraded noticeably over time, the TCT teeth may be worn or have accumulated resin buildup. Clean the blade with a dedicated blade cleaner to remove pitch and resin deposits. If teeth are visibly chipped or the blade no longer cuts true, it is time for a replacement or professional resharpening.

Blade wobble is typically caused by an improperly seated blade, a worn arbor, or a missing or incorrectly fitted washer. First, ensure the washer set (included with this blade) is correctly installed on both sides of the blade. Confirm the arbor nut is tightened to the correct torque. If wobble persists, inspect the saw's arbor for wear or damage. A bent blade can also cause wobble — if the blade body is visibly warped, it must be replaced immediately as this is a safety hazard.