✅ Significantly more direct feedback to the driver
✅ Durable bushings
✅ Chassis can react faster & more accurately

EXACT GEOMETRY

Factory landing gear bushings tend to be soft for comfort and provide a degree of play at the linkage. However, the forces occurring at the wheel are then transmitted to the chassis in a distorted manner and vice versa. As a result, the chassis is sluggish and cannot react to these forces to the full extent of its capabilities. This also applies to the driver. With harder bushings, this play can be reduced to a minimum and the chassis can be fully exploited.

If values ​​such as camber, track, caster, etc. are set, the vehicle is at a standstill. If it is now set in motion, there will be slight deviations from these values ​​due to the intended play in the factory rubber bushings. While these deviations are negligible in road traffic, they can make the difference between victory and defeat at the limit. Hard bushings reduce this play to a minimum and ensure that you always ride at the exact values ​​you set.

The set includes the following sockets:

- 2x Front axle lower wishbone bushing - center version or
- 2x Wishbone bushing front axle M3 - eccentric version
- 2x front stabilizer bush
- 2x Front connecting rod bushing
- 2x Rear axle trailing arm front bush
- 2x Rear axle upper wishbone inner bush
- 4x Rear axle lower wishbone outer bush
- 2x Rear axle lower wishbone inner bush
- 2x rear stabilizer bush
- 2x Bush rear tie rod, stabilizer bar side
- 2x Bush rear connecting rod, wishbone side
- 2x Rear axle carrier spherical bearing front bush
- 2x Rear axle carrier barrel bearing rear bush
- 1x Rear axle, differential mount front bushing or
- 1x Rear axle differential mount front bushing (M3 Evo model)
- 2x Rear axle, differential mount rear bush

DETAILS

Note: Bushing 031525 only fits the connecting rod that mounts on the handlebar. It does not fit the tie rod that connects the stabilizer bar to the shock absorber.
Does not fit E36 M3 and Z3M.

When ordering, please specify the appropriate diameter of the anti-roll bar. The eccentric control arm bushings (031369A) can also be installed on all other models. This allows you to adjust the caster of the front wheels!

Do you only need individual sockets from this set? No problem, just write us one E-mail or call us.

Delivery: Complete bushing set front axle & rear axle, mounting grease

TECHNICAL DATA